Installing The Moniceiver - Waeco PerfectView MC402 Instrucciones De Montaje

Installing the moniceiver

7 Installing the moniceiver
A
NOTICE! Beware of damage!
Before installing the monoceiver, remove the two screws used to
protect it during transport so that the DVD player can function.
7.1 Notes on the electrical connection
Please observe the following instructions relating to the electrical connection:
 This device is intended for use only in vehicles with 12 Vg and negative
earth. Ensure that the vehicle has the required 12 V voltage before install-
ing the device. If no voltage of 12 Vg is available, then a voltage con-
verter must be used.
 If the ignition socket of your vehicle does not have an ACC position
(starter battery), install a switch between the ACC cable and the power
supply.
 If you have put in a new fuse, but faults still occur, then approach the man-
ufacturers (see addresses on back), the manufacturers' customer service
department or a similarly qualified individual.
 Ensure that all electrical connections and the loudspeaker cables are well
insulated in order to avoid short circuits.
 Ensure that the screws for protecting the device during transport (fig. 6 1
page 5) are removed from the upper side of the device prior to installation.
7.2 Installing and connecting the moniceiver
A
NOTICE! Beware of damage!
 When drilling holes, check beforehand that there is sufficient
space on the other side for the drill head to come out.
 Cables and connections that are not properly installed will
cause malfunctions or damage to components. Correct instal-
lation of cables and connections ensures lasting and trouble-
free operation of the retrofitted components.
Observe the following installation instructions:
 When laying the cables, make sure:
– they are not kinked or twisted
– they do not rub on edges
– they are not laid in sharp-edged ducts without protection (fig. 3,
page 3).
30
MC402
EN