Channel Controls - Alto Professional TMX160DFX Manual De Inicio Rápido

INPUTS
1. MONO INPUTS – Connect a microphone or line level instrument to these inputs using
standard XLR or ¼" cable.
2. MONO Channel INSERT - Connect external sound processors such as compressor-limiter,
equalizers, etc. The Insert sockets can be used as direct-outs to feed the input of a 4-track
tape recorder.
3. STEREO INPUTS-
input will operate in mono mode, (the mono signal will appear on both input channels).

CHANNEL CONTROLS

4. PHANTOM PWR Switch - Applies +48 Volt Phantom Power only to the XLR MIC input.
When condenser microphones are not used, make sure that the Phantom Power is
disengaged.
5. MONO IN GAIN – Adjusts the signal for mic and line level sources.
6. LEVEL LED – Activates when there is an incoming signal.
7. LOW CUT Button - Activates a 75 Hz low frequency filter to reduce hum noise or
microphone rumble.
8. STEREO IN GAIN – Adjusts gain for the stereo line level channels.
Stereo pair ¼" TRS connections. If you connect only to the left jack, the
3
MIC 1
1
LINE IN
2
INSERT
1
LINE IN 9
3
LINE IN 10
4
+48V (CH1-4)
6
1
5
-30dB +15dB LINE
0dB +44dB MIC
7
LOW CUT
75HZ
18dB/OCT
8