Installing The Starter Battery - Efco EF 95 Instrucciones De Montaje

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 26
locking nuts.
5. Connect the top part to the support
plates and screw on using 2 Torx Tx30
and four carriage bolts (14 and 15).
6. Trap the fabric of the grass catcher in the
top part (16).
7. Put on the grass catcher cover and screw
it onto the frame (18 and 19).
Note: Oval-head screw (Torx) M6x22
and washer Ø 6x18.
8. Insert the hand lever through the grass
catcher (20), secure the oval-head screw
(Torx) M6x35 and self-locking nut to
prevent them being pulled out (21).

INSTALLING THE STARTER BATTERY

The lawn tractor is supplied with a starter
battery.
The starter battery mount is located under
the engine cover.
The starter battery is always supplied from
the factory pre-charged.
WARNING!
Danger if the starter battery is not
handled correctly!
Please comply with the following
points to avoid dangers from incorrect
handling of the battery!
- Do not store the starter battery in the
immediate vicinity of naked flames, do
not burn it or place it on heaters. Risk of
explosion.
- Keep the starter battery in a cool, dry
room (10 - 15 °C) over winter. Avoid
storing at temperatures below the
freezing point.
- Do not leave the starter battery without
charge for a long period. If the starter
battery is not used for a long period, it
should be charged using a suitable
charger.
- Do not smash the starter battery. The
electrolyte (sulphuric acid) causes
chemical burns to the skin and clothing -
immediately rinse away with plenty of
water.
- Keep the starter battery clean. Only wipe
clean with a dry cloth. Do not use water,
petrol, thinners or the like for this
purpose!
- Keep the connection terminals clean and
grease them with terminal grease.
- Do not short-circuit the connection
terminals.
1. Remove the ignition key (25b).
2. Open the engine cover.
CAUTION!
Danger of short circuit!
To avoid a shor t circuit, always
disconnect the negative cable (-) of the
battery first!
Always remove the ignition key before
starting work on the battery!
3. Connect the battery cables to the
connection terminals of the battery (28).
Check the polarity:
- Red terminal = positive terminal (+)
- Black terminal = negative terminal (-)
GB
13
Tabla de contenido
loading

Este manual también es adecuado para:

Ef 105Ef 125Om 95Om 105Om 125

Tabla de contenido