Cleaning And Servicing The Filter - IPCGansow 1202 Manual De Instrucciones

After you have ended your work, disable the selected programme (1-2-3) and turn off the engine by flicking the toggle
switch – " N " to OFF.
Before leaving the machine, make sure that the side brushes are raised from the floor, the parking brake is engaged and
that the ignition key has been take out of the instrument board.
This machine can be fitted with visual and acoustic devices signalling when the waste bin
is full – see letter " Q ". When the 'waste bin full' indicator light comes on, at the same time
the code CPUU will start flashing on the display. Empty the bin.
For the machine fitted with a waste bin with ground discharge, the emptying operation is
effected as follows:
1-Move to the waste container.
2-Pull lever "M" that locks/releases the bin.
3-Pull out the bin and empty it.
4-Refit the bin and lock it in place with lever "M"
For the machine fitted with a waste bin with raised discharge, the emptying operation is
effected as follows:
1-Pull lever "M" that locks/releases the bin.
2-Remove the bin and raise it to the requested height, then
move to the waste container.
3-Pull lever "N" to rotate the bin.
4-Rotate the bin to its horizontal position; move away from
the waste container.
5-Raise the bin to disable the safety system, then lower it to
refit it into the machine.
6-Lock the bin in place with lever "M".
The filter is a very important component of the machine and essential for correct operation.
Proper filter maintenance will allow you to obtain the best performance from your machine.
The filter can be cleaned in any of the following three ways:
1) by means of the automatic cleaning system
According to the chosen work programme, the machine is programmed to automatically clean the filter at regular preset
intervals.
2) by means of an electric filter shaker that is manually started
Just a simple command is needed to keep the filter in perfect working order: press the button marked " F "and hold it
down for a few seconds. Repeat this operation 4 or 5 times.
Remember that the cleaner the filter, the better the results of your cleaning session. It is recommended to carry this
operation out at the end of each work cycle.
NOTE: dusty environments
If you are using the machine in a dusty environment (e.g. sawmills – warehouses where haulage vehicles pass, etc.), it is
a good idea to use the filter shaker more frequently.
3) by manually cleaning the filter
If operating the filter shaker is not enough to keep the filter clean - and in any case every 20 hours of work - clean the
filter manually. Before carrying out any kind of intervention on the machine, make sure it is turned off and that all
functions are deactivated. To obtain this condition, turn the switch marked " O " to OFF.
1° Remove the rear machine panel
2° Take the filter out of its seat by turning the 2 retainer handles.
3° Blow compressed air (at a pressure of 6 bar at the most).
4° Refit the filters and the rear panel.
ENGLISH (
Translation of original instructions)
EMPTYING THE WASTE BIN

CLEANING AND SERVICING THE FILTER

M
N
7