Setting Up Programmed Operations - Panasonic CZ-ESWC2 Manual De Instrucciones

Setting Up Programmed Operations

Correctly set the present time and today's day of the week.
Unless both are correctly set, the programs will not run as expected.
• Up to 6 programmed operations can be set per day for each group and day
of the week.
• A combination of the below operations can be set for each timer program.
– Air conditioner starting/stopping
– Remote controller operation enable/disable *1
• To change the settings of an existing program, use the same below
procedure used to set up a new program.
*1 The remote controller operation enable/disable setting is disabled
depending on installation conditions. If so,
the button is pressed.
For more information, contact your dealer.
STEP 1 Press the PROGRAM button to select a group.
• When the PROGRAM button is pressed, the group
No. and today's day of the week start blinking and the
present time indication changes to a blinking "PG-1".
• Press the GROUP button to select a group for
programmed operation and then press the SET
button.
NOTE
• Group selection is disabled depending on installation
conditions. If so, proceed to the next step.
• The number of selectable groups is set during
installation.
STEP 2 Press the DAY button and select a day of the week for
programmed operation.
• When the SET button is pressed, the program
schedule marker (
lighting and, at the same time, the time set in program
starts blinking. Also, the present time indication
changes to a blinking "PG-2".
NOTE
• The currently selected day of the week blinks slowly at
this time.
EN-8
appears on the display when
) changes from blinking to
Example settings