MTD OEM-190-180A Manual Del Usuario página 13

6. Slide the hinge pin into the hole located on the mounting
tab, as in Figure 4-16. Use the cut-out window (See inset in
Figure 4-17) to line up the hinge pin on the other side and
push pin all the way in until it reaches the end-stop. At this
point the pin clips into place and is secured by a tab in the
bagger cover. See Figure 4-17.
Figure 4-16
Figure 4-17
7. Open Hood by pushing in on the rear, right-side tab with
your right hand, as seen in 1 of Figure 4-18, and lifting the
cover with your left hand in the center rear of the bagger
cover, 2.
2
Figure 4-18
8. Install both bag assemblies onto the bag support brackets
by inserting the front edge in first, as seen in Figure
4-19, and setting the back edge down until it fits into the
assembly.
1
Figure 4-19
S
ection
1
2
4 — A & i
SSembly nStAllAtion
13