Areas Of Use; Filling With Petrol - Stiga PARK PLUS Instrucciones De Uso

EN
2.4.15 Engine casing (8:U)
In order to access the fuel cock, battery
and engine, the machine has an engine
casing that can be opened. The engine cas-
ing is locked with a rubber strap.
The engine casing is opened as follows:
1. Undo the rubber strap (8:V) at the front edge of
the casing.
2. Carefully lift the engine casing back.
Close in the reverse order.
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.
2.4.16 Quick-release mounting (25:H)
The quick connections can be separated,
which makes it very easy to shift between
the different implements.
The quick connections allow the deck to
be moved easily between the two posi-
tions:
• Normal position with fully tensioned belt.
• 4 cm behind the normal position with slackened
belt so that the deck gets closer to the base ma-
chine.
As the belt idler is released from the belt, the quick
connections simplify belt and deck replacement,
and also make shifting to the washing position and
service positions easier.
Releasing the belt tension:
1. Remove the locking pins (25:G) from both
sides.
2. Open the quick connections by depressing their
rear sections with your heel. See (25:F).
When the quick connections are
opened, the deck arms rest loosely in
the shaft sections. The deck must never
be set to the service position or washing
position without relocking the quick
connections after unhooking the deck
belt.
3. Carry out the necessary corrective action, e.g.:
• Unhook the belt.
• Replace the deck by unhooking the deck arms.
See fig. 27.
Tensioning the belt:
First tension one side and then the other according
to the instructions below.
Do not turn the lever using your hands.
Risk of crushing injuries.
1. Place your foot on the lever (26:J) and carefully
turn a half turn forwards.
2. Install the locking pin (25:G).
3. Carry out the above on the other side.
64
ENGLISH

3 AREAS OF USE

The machine may only be used for the following
tasks using the genuine STIGA accessories stated.
Work
Mowing
Sweeping
Snow clearance
Grass clipping and
leaf collection
Grass and leaf
transport
Sand spreading
Weeding on grav-
el paths
Lawn edge trim-
ming
Moss scarification Using moss scarifier.
The maximum vertical load on the towing hitch
must not exceed 100 N.
The maximum over-run load on the towing hitch
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven
on public roads.
4 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed and
locked. Risk of burns and crushing in-
juries.

4.1 FILLING WITH PETROL

Always use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 12 litres. The level can easily be
read through the transparent tank.
NOTE! Ordinary lead-free petrol is a perishable
and must not be stored for more than 30 days.
Accessories, STIGA genuine
Using mowing decks: 95
Combi, 95 Combi El, 100
Combi 3, 100 Combi 3 El, 105
Combi, 105 Combi El, 110
Combi Pro, 110 Combi Pro El,
Flail mower
Using brush unit or collector
brush unit. The use of a dust
guard is recommended with
the first option.
Using snow blade or snow
thrower Snow chains and frame
weights are recommended.
Using towed collector 38" or
42".
Using dump cart Pro or
Combi.
Using sand spreader. Can also
be used for spreading salt.
Snow chains and frame
weights are recommended.
Using front-mounted hoe.
Using edge trimmer.