Implements - Grillo G84 Manual De Instrucciones

6) Even impossible ground can be tilled, but the machine must be well run-in first.
7) Check the tyre pressure often.
8) When fitting the implements (e.g. rotary tiller) take care not to damage the centring device (see
chapter on «Implements»).
END OF SEASON MAINTENANCE
Clean the machine carefully; change the engine, gearbox and tiller gearbox oil. Clean the air filter.
Sharpen and grease the blades, replacing them if worn.
PROCEDURE
check the level
Engine oil
Air filter
check/adjust
Spark plug
Check the level
Gearbox oil
Check that the engine intake grid is
clean
Check blade
Cutter bar
Check that tines are well-sharpened
and well-fixed
Lubricate with grease
Check clutch clearance (free play)
● recommended procedure
‫ ٭‬procedure to be carried out if necessary
ROTARY TILLER
The rotary tiller is used to break the surface layer of the ground in order to increase its permeability
and at the same time to rid of weeds. Till in first speed if the soil is hard and tough or in second
speed in soft, sandy soil. The working depth can be adjusted by lifting or lowering the central knife
situated under the rotary unit (fig. 4B). The tiller cover position will change at the same time. Raise
the knife to increase the depth. Start work with the knife in its lowest position, and then raise it if
greater depth is required (fig. 4B).
Translation of the Original Instructions
MAINTENANCE SUMMARY TABLE
EVERY 8
HOURS
change
(running-in)
check
replace
replace
replace
attachment
grease

IMPLEMENTS

AFTER
20
HOURS
●
●
●
●
●
●
●
●
●
●
10
EVERY EVERY
50 100
HOURS HOURS
●
‫٭‬
●
●
●
●
●
ONCE A
YEAR OR
EVERY
200
HOURS
●
●