V2 WES-ADI Manual De Instrucciones página 15

LED SIGNALS ON THE BASE UNIT
Status GREEN LED
Operative - Slow flashing if the
(normal network is not
operation - configured.
J1 in position 1)
- One flash for each
transmission received
from a sensor.
Network Slow flashing until
configuration the first sensor is
inserted, then one
flash for each
message received.
Deleting the Slow flashing.
network
TEST mode On and fixed.
(network
configured
J1 in position 2)
Channel One, two or three
programming flashes to indicate
(network not channel quality
configured (quality above mean
J1 in position 2) level)
LOW BATTERY SIGNAL
If the sensor battery level is low, the WES-ADI base unit communicates this to the control unit, which can then emit a signal depending on
the programmed settings.
RED LED YELLOW LED
Fixed and on, under Off.
alarm conditions.
Rapid flashing in the
case of low battery.
Flashing. Off.
1 flash = group 1
2 flashes = group 2
3 flashes = both
groups
Slow flashing. Off.
Fixed and on, under Sequence of from 1 to
alarm conditions. 16 flashes to indicate
the channel on which
Rapid flashing in the the network is
case of low battery. configured.
One, two or three Sequence of from 1 to
flashes to indicate 16 flashes, repeated
channel quality every second, to
(quality below mean indicate which channel
level) is having the quality
displayed
15
Possible actions
Briefly press the PROG key to switch to
group 1 network configuration mode.
Press and hold the PROG key for some
time to delete the network.
Repeated pressing of the PROG key
switches to group 2, both groups and
then exits the procedure, in sequence.
After 15 seconds inactivity, the device
returns to working mode.
Pressing the PROG key returns to
working mode.
After 5 seconds inactivity, the device
returns to working mode.
Each pressing of the PROG key runs
through the various radio channels in
sequence.