Kreg Jig Jr Manual De Instrucciones página 3

Jig Settings
To create the strongest joint possible, you'll need to set your
jig to match the thickness of your workpiece. The
Kreg Jig ® Jr. makes this easy, in just two simple steps!
For ⁄ " material, place the step of the bit as far forward as it will go and
3
4
tighten the depth collar at the
3
To get the right Pocket-Hole depth, you'll fi rst have to
adjust the position of the Depth Collar on the Drill Bit. The
collar prevents the your drill from plunging too far into the
workpiece, so its position is essential.
Begin by placing the bit inside the Depth Setting Gauge
found inside of the Kreg Jig
the bit as far forward as it will go, then slide the Depth
Collar onto the shank of the bit until it reaches the marking
which matches your workpiece thickness, as shown. Lock
the Depth Collar fi rmly into place with the included Allen
Wrench.
www.kregtool.eu
⁄ " (1.905cm) marking.
4
® Jr.'s case. Place the step of
To ensure the exit-point of your screw is at the centre of the
workpiece for the strongest joint possible, you'll also need to
adjust the Positioning Sliders on either side of the Kreg Jig
Positioning Sliders shown set for
On the bottom of each Positioning Slider there are markings
which represent different material thicknesses. Press each
slider with your thumb and slide it until the marking which
matches the thickness of your workpieces comes into alignment
with the large arrows on the bottom of the jig, as shown.
Inches
1/2"
5/8"
3/4"
7/8"
1"
1-1/4"
1-1/8"
1-1/2"
1-3/8"
Jig Settings
⁄ " (1.905cm) thick material.
3
4
Metric
12 mm
16 mm
19 mm
22 mm
25 mm
32 mm
29 mm
38 mm
35 mm
www.kregtool.eu
® ® Jr.