Starting manually
without remote throttle control, with choke
Choke
On
Off
1. Set the choke at position 1 (
2. Pull in the safety brake handle on the handlebar and
hold it (
17) – the brake handle does not lock.
3. Pull out the starter cord sharply, then allow it to
slowly rewind (
18).
4. When the motor has warmed up (about 15–20
seconds), set the choke to position 2 (
Motor speed (rpm value) is fixed.
Motor speed cannot be adjusted.
without remote throttle control, with primer (
1. Press the primer button 3 times at intervals of about
16). If the temperature is below
2 seconds (
10 °C, press the primer button 5 times.
2. Pull in the safety brake handle on the handlebar and
hold it (
17) – the brake handle does not lock.
1. Pull out the starter cord sharply, then allow it to
18).
slowly rewind (
Motor speed (rpm value) is fixed.
Motor speed cannot be adjusted.
without remote throttle control, without primer/
choke
2. Pull in the safety brake handle on the handlebar and
17) – the brake handle does not lock.
hold it (
3. Pull out the starter cord sharply, then allow it to
18).
slowly rewind (
Motor speed (rpm value) is fixed.
Motor speed cannot be adjusted.
470 591_e
13/1).
13/2).
16)
with remote throttle control, with choke
Remote throttle
control with choke
1. Set the throttle lever to position
2. Pull in the safety brake handle on the handlebar and
hold it (
17) – the brake handle does not lock.
3. Pull out the starter cord sharply, then allow it to
slowly rewind (
18).
4. When the motor has warmed up (about 15–20
seconds), set the throttle lever to a position
between
and
with remote throttle control, without primer/choke
Remote throttle
control
Start
Stop
5. Set the throttle lever to position
6. Pull in the safety brake handle on the handlebar and
hold it (
17) - the brake handle does not lock.
7. Pull out the starter cord sharply, then allow it to
slowly rewind (
18).
8. When the motor has warmed up (about 15–20
seconds), set the throttle lever to a position
between
and
GB
14/1).
(
(
14/2).
20/1).
(
(
20).
29