FALLING OR SLIDING OUT.
ALWAYS USE COMPLETE 5 POINT
SEAT BELT.
WARNING
_
NEVER LEAVE YOUR CHILD
UNATTENDED.
_ ALWAYS USE ALL THE BRAKES
WHENEVER PARKED.
_ TO AVOID SERIOUS INJURY,
WHEN MAKING ADJUSTMENTS
ENSURE THE CHILD'S BODY IS
CLEAR OF ALL MOVING PARTS.
_ ALL OPERATING AND
ASSEMBLY PROCEDURES
SHOULD BE PERFORMED BY
AN ADULT.
_ DO NOT LIFT THE STROLLER
BY GRIPPING THE FRONT
BAR. THE FRONT BAR IS NOT
DESIGNED TO WITH STAND
LOADS.
_ ENSURE THAT THE STROLLER
IS OPENED CORRECTLY AND
LOCKED IN POSITION OF USE.
_ CHECK TO MAKE SURE THAT
THE CAR SEAT OR THE BABY
CARRIAGE IS CORRECTLY
FASTENED TO THE STROLLER
(WHERE APPLICABLE).
_ DO NOT DRIVE THIS PRODUCT
AROUND STAIRS OR STEPS;
CARE MUST BE TAKEN IF
UNIT IS USED ON STAIRS OR
ESCALATORS.
_ DO NOT USE THE PRODUCT IF
IT HAS BROKEN OR MISSING
PARTS.
_ DO NOT USE NEAR FIRE OR
EXPOSED FLAME.
WARNING
_
KEEP CHILDREN AWAY WHILE
OPENING AND CLOSING TO
AVOID TRAPPING OR INJURY
WARNING
_
DO NOT ADD ANY MATTRESS
ARE NOT APPROVED BY THE
MANUFACTURER.
_
NOT MAKE ANY ALTERATIONS
:
OR MODIFICATIONS TO THE
STROLLER WITH PRODUCTS
NOT SUPPLIED BY THE
MANUFACTURER AS THIS
MAY CAUSE INSTABILITY OR
STRUCTURAL DEMAGE NOT
COVERED UNDER WARRANTY.
NOTICE
THIS ARTICLE MEETS OR
EXCEEDS ALL REQUIREMENTS
COVERED IN ASTM F833
STANDARD AND LATEST
REVISIONS.
PRODUCT PARTS
Check the package contents and contact our
Customer Service for any claim.
_ The PLIKO MINI TWIN stroller is equipped
with: 3 lockable or swivelling front wheel
sets, 1 set of rear wheels, a basket and 2
hoods.
INSTRUCTIONS
1 Before opening the stroller, remove the
protection pads from the hooks of the frame
(fig_a),
OPENING: to open the stroller, unhook the
left hand side lever (fig_b), hold the handles
and at the same time lift the stroller (fig_c)
Check that it has been opened correctly,
making sure the side and central hooks are
hooked well (fig_d).
2 If the hooks are not secured properly, press
the seat downwards (fig_e) until they click
into place. Finally, press downwards on PUSH
with your foot (fig_f).
3 ASSEMBLY: to fit the front wheels, lower the
lever (fig_a) and insert the wheel (fig_b) until
it clicks.
4 To mount the rear wheels connected by the
:
brake cable, place them with the brake facing
externally (fig_a).
WARNING: ensure the hooks have clicked into
place, as in figure b.
5 Finally, hook the central parts onto the brake
bar of the frame, checking that everything
:
has been hooked correctly, as in the picture.
6 BASKET: to fit the basket onto the stroller, slip
the eyelets onto the rear side hooks (arrows
1 and 2) and the front hooks (arrow 3), and
then connect them to the front and rear
central hooks (arrow 4) (arrow 5), (fig_a).
ADJUSTING THE HANDLES: the height of
- 12 -
WARNING
:
DO