Tabla de contenido
OPERATING INSTRUCTION FOR INDUSTRIAL SECTIONAL DOOR AUTOMATIONS DOD
INSTRUCTIONS FOR MANUAL OPERATION
Warning: the sectional door may not be correctly balanced.
The door release and manual moving operations must be
carried out with the DODSBV-DODSBO handle release devices
(fig.1) or the DODSBC chain release device (fig.2).
In the event of a fault or power failure, press the emergency stop
[1] (TOTAL STOP) and manually raise/lower the sectional door
[2] using the handle (fig.1) or chain (fig.2).
GENERAL SAFETY PRECAUTIONS
The following precautions are an integral and essential part
of the product and must be supplied to the user.
Read them carefully as they contain important indications for
the safe installation, use and maintenace.
These instruction must be kept and forwarded to all possible
future user of the system.
This product must be used only for that which it has been ex-
pressely designed.
Any other use is to be considered improper and therefore dange-
rous. The manufacturer cannot be held responsible for possible
damage caused by improper, erroneous or unresonable use.
Avoid operating in the proximity of the hinges or moving me-
chanical parts.
Do not enter the field of action of the motorised door or gate
while in motion.
Do not obstruct the motion of the motorised door or gate as this
may cause a situation of danger.
Do not lean against or hang on to the barrier when it is moving.
Do not allow children to play or stay within the field of action of
the motorised door or gate.
Keep remote control or any other control devices out of the reach
of children, in order to avoid possible involuntary activation of
the motorised door or gate.
In case of breack down or malfunctioning of the product, discon-
nect from mains, do not attempt to repair or intervene directly
and contact only qualified personnel.
Failure to comply with the above may create a situation of
danger.
All cleaning, maintenance or repair work must be carried out by
qualified personnel.
In order to guarantee that the system works efficiently and
correctly it is indispensable to comply with the manufacturer's
indications thus having the periodic maintenance of the motorised
door or gate carried out by qualified personnel.
In particular regular checks are recommended in order to verify
that the safety devices are operating correctly. All installation,
maintenance and repair work must be documented and made
available to the user.
DITEC S.p.A.
Via Mons. Banfi, 3
21042 Caronno Pertusella (VA) - ITALY
Tel. +39 02 963911 - Fax +39 02 9650314
www.ditec.it - [email protected]
ON
OFF
For the correct disposal of electric and electronic equip-
ment, waste batteries and accumulators, the user must take
such products to the designated municipal collection facilities.
Installer:
Fig. 1
Fig. 2
.p.A
.
DITE
C
S
. BAN
FI,3
P.L
LA
(VA)
C AR
M
V IA
O
IT
ALY
AX.02/9
NS
ONNO
650314
21042
963911
F
DOOR
TEL.02/
TYPE
00000
ACTURE
YEAR
0000
MANUF
OF
SUPPL
Y
VOLTAGE
000V
NUMBER
00000
0
SERIAL
00000
in
Italy
Made
Tabla de contenido
