Service & Maintenance; Warning Decals; Warning Symbols - Altrad Belle PCEL 320X Manual Del Operador

GB
Maintenance
The Altrad Belle 'PCEL 320X' is designed to give many years of trouble free operation. It is recommended that an approved Altrad Belle
dealer carries out all major maintenance and repairs. Always use genuine Altrad Belle replacement parts, the use of spurious parts may
void your warranty.
Before any maintenance is carried out on the machine, switch off the engine and disconnect the HT lead from the sparkplug.
Always set the 'PCEL 320X' on level ground to ensure any fl uid levels will be correctly read. Only use recommended oils (see chart on
following page).
Running In Period
When the 'PCEL 320X' is fi rst used from new, the engine oil must be changed after the initial running in period (see engine manual for
full detail). The vibrator shaft case oil must be replaced after the fi rst 100 hours use, then after every 500 working hours. For detail on
vibrator shaft case oil replacement, see 'Vibrator unit'. The belt tension should be checked after 4 hours use.
Routine Maintenance
Engine Oil
Air Filter
Spark Plug
Drive Belt
Oil / Fuel Type & Quantity - Spark Plug Type
Petrol Honda GXR120
Vibrator
GB
Wear Ear Protection
Wear Eye Protection
This Way Up
Service & Maintenance
Check Level
Change
Check Condition
Clean / Replace
Check / Clean
Tension
Oil type Quantity
S.A.E. 10W 30
Turbine Oil 32
Vibrator Unit.
Remove the plug complete with seal, check that the oil level reaches the bottom thread on the oil
plug hole. Top up as necessary with the correct oil (see chart).

Warning Symbols

Fire And Explosive
Risk
Wear Protective
Footwear
Do Not Hang
After First
4 hours
Fuel Type
(Litre)
0.6 Unleaded
0.22 N/A
12
First month / 3 Months
20Hours 50 Hours



 
Capacity Spark Plug
(Litre) Type
2.0 BM4a or
BmR4a
N/A N/A
Caution Taken When Handling
Read This Manual
6 months
100 Hours





Electrode
Gap (mm)
0.6 - 0.7
N/A