3.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
Keep this device away from dust and extreme heat. Make sure the ventilation openings are
clear at all times.
Protect this device from shocks and abuse. Avoid brute force when operating the device.
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation by
unqualified people. Any damage that may occur will most probably be due to unprofessional use of the
device.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications to
the device is not covered by the warranty.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
crash, etc. Using the device in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
•
Lamps and mechanical wear are not covered by warranty.
•
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
•
After connecting the device to the mains, wait at least 15 minutes before disconnecting and vice versa.
•
Use the original packaging if the device is to be transported.
4.
Features
•
with a high power white LED
•
super luminance, rich and splendid colours
•
comparable with a traditional 250W moving head
•
low power consumption
•
long life time
•
7 rotating (with shaking mode) gobos, 9 colours + white
•
DMX controlled via 8 or 14 channels
•
stand-alone mode with 8 built-in programs, and music control function
•
wide range, horizontal angle of 540° and vertical of 270°, in 8- or 16-bit mode
•
super smooth scanning
•
high speed electronic strobe function
•
master dimmer function 0-100%
•
digital display for easy configuration, can be reversed for 180°, auto switch off after 5 sec.
5.
Installation
Refer to the illustrations on page 2 of this manual.
Overhead mounting
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The construction to which the device is attached should be able to support 10 times the weight of the
device for one hour without deformation.
•
The installation must always be secured with a secondary attachment e.g. a safety cable [13].
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by and inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in serious injuries.
•
Screw the mounting brackets (incl.) on the base [4] (2 screws per bracket). Then mount suitable clamps
(not incl.) on the mounting brackets.
V. 02 – 03/05/2012
VDPL601MHx14
6
©Velleman nv