oPeratioN
1. Take the kettle jug from the base.
2. To fill the kettle jug with water, release the
lid by pressing the button on the upper part
of the handle.
3. Fill the kettle jug with at least 0.5 litres of
water. The maximum capacity of the kettle
jug is of 1.7 litres („Max" mark).
4. Close the lid by pressing slightly until it
latches into place.
5. Put the kettle jug straight on the base in
order to establish the electrical contact with
the base.
6. To boil water, switch the appliance on
by pushing the switch up to the position
„Kochen". The switch lights up in blue. The
water will be heated to 100 °C.
7. To boil water for e.g. green tea, switch
the appliance on by pushing the switch
down to the position „Heisswasser". The
switch lights up in red. The water will be
heated to approx. 75 °C, which is the ideal
temperature for tea. Please bear in mind
that the mode „Heisswasser" will not work if
in the same boiling process water has been
heated in the mode „Kochen" and achieved
a temperature of more than 75 °C.
8. If the kettle jug is not placed correctly, it
will not be possible to turn the appliance on.
cleaNiNg aND care
1. Allow the appliance to cool before cleaning it.
2. Before cleaning, always turn off the appliance and
unplug it from the power supply.
3. Do not immerse the base, power cord or
kettle in water or other liquids or wash them
in the dishwasher.
4. Wipe off the base and the kettle with a damp
cloth and a little dishwashing detergent. Do
not use any abrasive scouring agents, steel
DeScaliNg
1. The lime scale filter has to be cleaned
regularly.
Please
completely and allow it to cool off. Carefully
remove the filter from the pour spout. Clean
the filter carefully with a soft brush under
running water. You can also place the filter
in a bowl with a descaling solution. Then
12
empty
the
kettle
9. The automatic shutoff will switch the
appliance off when the water has achieved
the pre-adjusted temperature.
10. When the kettle jug is lifted from the base,
the automatic shutoff is activated, even
when the water has not yet reached the pre-
adjusted temperature.
11. If you desire to finish the boiling process
earlier, just lift the kettle jug from the base.
The automatic switch-off will disconnect the
appliance.
12. Caution! The automatic shutoff only works
when the lid is closed properly.
13. In case you need to boil more water, first
leave the appliance to cool off for a couple
of minutes.
14. Boiling water may cause scalding. Please
handle the appliance with care when it
contains hot water.
15. The appliance features boil dry protection,
which automatically shuts the appliance
off when operated without water or with
resistant
calcinations.
appliance cool off shortly before filling the
kettle jug with water again, respectively
descale the appliance as described in the
chapter „Descaling" on page 12.
wool, metal objects, hot cleaning agents or
disinfectants, since they can damage the
appliance.
5. The appliance must be completely dry on
the outside before you use it again.
rinse the filter with clear water and insert it
in the pour spout.
2. To keep the appliance operating efficiently
and to prolong its service life, it should
be descaled regularly, depending on the
hardness of your water.
Please
let
the