Overview - Rockwell Automation Allen-Bradley MicroLogix 1500 1764-24AWA Instalación E Instrucciones De Operación

Overview

Install your controller using these installation instructions.
ATTENTION: Do not remove protective debris strips until after
the base and all other equipment in the panel near the base is
!
mounted and wiring is complete. Once wiring is complete,
remove protective debris strips and install processor unit. Failure
to remove strips before operating can cause overheating.
ATTENTION: Be careful of metal chips when drilling
mounting holes for your controller or other equipment within the
!
enclosure or panel. Drilled fragments that fall into the controller
could cause damage. Do not drill holes above a mounted
controller if the protective debris strips have been removed.
ATTENTION: Electrostatic discharge can damage
semiconductor devices inside the base unit. Do not touch the
!
connector pins or other sensitive areas.
MicroLogix™ 1500 Programmable Controller Base Units
Protective
Debris Strips
ESD Sticker
Publication 1764-5.1
5