Adjusting The Carburetor - Stihl BR 450 Manual De Instrucciones

English
3
Remove the filter element (3).
N
Replace dirty or damaged filters.
N
Fit the new filter in the filter housing.
N
Fit the filter cover.
N
Fit the screws and tighten them
N
down firmly.
22

Adjusting the Carburetor

General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
Preparations
Shut off the engine.
N
Check the air filter and clean or
N
replace if necessary.
Check that the throttle cable is
N
properly adjusted – readjust if
necessary – see chapter on
"Adjusting the Throttle Cable".
Check the spark arresting screen
N
(not in all models, country-specific)
in the muffler and clean or replace if
necessary.
Standard Setting
L
H
Turn high speed screw (H)
N
counterclockwise as far as stop (no
more than 3/4 turn).
Turn the low speed screw (L)
N
clockwise as far as stop, then turn it
back 3/4 turn.
Adjusting Idle Speed
Carry out the standard setting.
N
Start and warm up the engine.
N
L
LA
Engine stops while idling
Turn the idle speed screw (LA)
N
slowly clockwise until the engine
runs smoothly.
BR 450, BR 450 C