Mi-T-M Corporation GEN-3000-1MH0 Manual Del Operador página 23

COnTROlS
CABLE SIZE:
Equipment damage can result from low voltage. Therefore, to prevent
excessive voltage drop between the generator and the equipment,
the cable should be of adequate gauge for the length used. The cable
selection chart gives the maximum cable lengths for various gauges of
wire which can adequately carry the loads shown.
CURRENT LOAD IN WATTS
IN AMPS 20 vOLTS
2.5 300
5 600
7.5 900
0 200
5 800
20 2400
25 3000
30 3600
40 4800
ELECTRIC MOTOR LOADS:
It is characteristic of common electric motors in normal operation to draw
up to six times their running current while starting. This table may be
used to estimate the watts required to start "CODE G" electric motors.
CAuTIOn: If An eleCTRIC mOTOR fAIlS TO START OR
ReACH RunnInG SPeed, TuRn Off THe
APPlIAnCe OR TOOl ImmedIATely TO AVOId
equIPmenT dAmAGe. AlWAyS CHeCk THe
RequIRemenTS Of THe TOOl OR APPlIAnCe
beInG uSed COmPARed TO THe RATed OuTPuT
Of THe GeneRATOR.
MOTOR (H.P.) RUNNING WATTS
/8
/6
/4
/3
/2
3/4

Operator's Manual
Operating the Generator
240 vOLTS #8 WIRE
600
200
800
2400
3600
4800 75
6000 50
7200 25
9600 90
REPULSION INDUCTION
275
275
400
450
600
850
00
MAXIMUM CABLE LENGTH (FEET)
#0 WIRE #2 WIRE
000 600
500 300
350 200
250 50
50 00
25 75
00 60
65
WATTS REQUIRED TO START MOTOR
CAPACITOR
600
600
850
975
300
900
2500
#4 WIRE #6 WIRE
375 250
200 25
25 00
00 50
65
50
SPLIT PHASE
850 200
850 2050
050 2400
350 2700
800 3600
2600
3300
23