Virax Mini VISIOVAL Manual Del Usuario página 27

5. When the battery is fully charged, the status LED indicator will change from red to
green
- When the battery is charged, the mini VISIOVAL can remain connected to the charger
until it is ready for use. There is no risk of overcharging the battery. When the battery is
fully charged, the charger automatically switches to trickle charging mode.
Note: The internal battery is provided with a partial charge. It is recommended that the battery be
fully charged for at least 5 hours before the first use.
Note: Servicing or replacement of the internal battery must be carried out by the Virax after-sales
service.
3.4. Installation of the Imager/Cable.
Only one imager(device) may be connected to the handheld device at any time. Ensure that
the handheld device is shut off when installing or removing imager.
To use the mini VISIOVAL inspection device, the imager cable must be connected to the
handheld device. To connect the imager(device), ensure that the key and the slot (Figure 5) are
properly aligned. Once aligned, tighten the knurled nut by hand to secure the connection.
Figure 5 - Cable connection (type A connector, 9 pins, Black)
(to be used with the standard imager, provided with the mini VISIOVAL and with the 16m cable for
mini VISIOVAL)
3.5. Installing the SD memory card
Locate tab on port cover (Figure 6), lift and pull to remove the cover to access to the SD card slot (SD
card included). Insert the SD card into the slot (Figure 7) making sure that the connectors are facing
you and that the bevelled part of the card is facing down.
Figure 6 – Slot lid and power switch
Slot
Plug
Port cover
Power switch
EN
27