Virax Mini VISIOVAL Manual Del Usuario página 20

Translation of the original instructions
Symbols found in this document
Danger
This symbol warns of a risk of injury.
Warning
This symbol warns of a danger of hardware damage and
environmental damage.
This product is covered by
U.S. Patents: 7,384,308; 7,431,619 B2; 7,581,988 B2; 7,584,534;
Chinese Patents: ZL200620147826.1; ZL200620147827.6; ZL2007200004596.8; and
other patents pending.
USA:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept any
interference received, including interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
End users must follow the specific operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter,
except in accordance with FCC multi-transmitter product procedures.
This equipment has been tested and found to comply with the limits for Class A digital devices,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equip-ment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver
•
Consult the dealer for help.
Use of shielded cable is required to comply with Class A limits in Subpart B of Part 15 of the FCC
Rules
Canada:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Note: All changes or modification not specifically approved by the person in charge of compliance
may void the user's authorisation to use the device.
20
EN