Unold 86706 Instrucciones De Uso página 22

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 50
3.
Fix the lower stand pipe in place
on the base by inserting it into the
opening in the base and firmly
screwing it in.
4.
Route the power cord through the
base and the lower stand pipe, so
that the power cord projects on
the upper end of the stand pipe
5.
Note that the plug for the electri-
cal outlet must poke out on the
underside of the base. The end of
the power cord, on which the con-
nection socket is mounted, must
be threaded through the pipe.
6.
Check whether the upper stand
pipe is completely pulled out. If
not, unscrew the locking ring, pull
the pipe out to its complete size
and screw fasten the locking ring.
7.
Thread the power cord through
the upper stand pipe. Now screw
the upper stand pipe firmly onto
the lower stand pipe.
8.
Connect the power cord socket on
the reflector. Then carefully place
the reflector on the upper stand
pipe. Use the provided screws
(M4x8) to fasten the reflector.
After you have connected plug and
socket, place the black protective
cap around both plug and socket
and lock the protective cap.
9.
Slide the upper stand pipe to the
desired height and fix it in place
at this height by firmly tightening
the locking ring. Caution: This
procedure is only possible if you
have properly complied with point
6, otherwise the power cord in the
interior of the pipe is too short.
10. The power cord must now be fixed
in place on the underside of the
base. To do this, use the screws
22
Copyright UNOLD AG | www.unold.de
Tabla de contenido
loading

Tabla de contenido