Tabla de contenido
Idiomas disponibles
Idiomas disponibles
n Remove lantern parts from package.
Igniter Electrode
Reflector
Ventilator-Globe-Bail
Assembly
n Always use genuine Coleman
mantles . If using Insta-Clip
follow the instructions on the mantle package.
n If using tie style mantles, tie mantles around
grooves in burner. (Fig. 1)
n Distribute folds on mantle evenly. Cut off
surplus string 1/4" (0.6 cm) from knot. (Fig. 2)
n For INSTASTART™ electronic ignition lanterns,
be careful that mantle does not snag
on electrode.
Fig. 1
n Light bottom of mantle evenly. Burn until
nothing but white ash remains. Once the mantle
has been burned, it is very fragile. Be careful
not to touch it with finger or match. (Fig. 3, 4)
Fig. 3
n Complete assembly. (Fig. 5, 6)
Fig. 5
To Light
WARNING
If you smell gas:
1. Do not attempt to light appliance.
2. Extinguish any open flame.
3. Disconnect from fuel supply.
4. Call 1-800-835-3278.
WARNING
• Replace any mantle with a hole in it. A hole
can cause lantern to overheat and create a
hazard. Never operate lantern without
heat shield.
Lantern Frame
Base
Ball
Mantles
Nut
#21 size
®
II tabbed mantles,
®
Fig. 2
Fig. 4
Fig. 6
English - 3
n Note: Use Coleman 16.4 oz. disposable propane
cylinders. The LP-gas cylinder(s) used with
lanterns must be constructed and marked in
accordance with the specifications for LP-gas
cylinders of the U.S. Department of Transportation
or Transport Canada, CAN/CSA B339.
n Take lantern
outdoors away from
ignition sources.
n Turn fuel valve off.
(Fig. 7)
Fig. 7
DANGER
• EXPLOSION - FIRE HAZARD
• Propane is heavier than air and can
accumulate in low places. If you smell gas,
leave the area immediately.
• Always attach or detach propane source
outdoors; never while lantern is lighted, near
flame, pilot lights, other ignition sources or
while lantern is hot to touch.
• Always light & use lantern outdoors.
• This lantern must not be exposed to
flammable vapors or liquids during lighting.
• This lantern is red hot during use and can
ignite flammables too close to the mantles.
Keep flammables at least 12 inches from
the sides and 48 inches from the top of the
lantern. Keep gasoline and other flammable
liquids and vapors well away from lantern.
n Always extend base before use. (Fig. 9)
n Screw propane
cylinder into lantern.
Take care not to
cross-thread. Hand
tighten only. (Fig. 10)
Fig. 10
n Remove protective
cap from top of
propane cylinder.
Save cap for use
in storing. (Fig. 8)
Fig. 8
Fig. 9
n Set lantern into base.
(Fig. 11)
Fig. 11
Tabla de contenido
