Accessmatic Fox 1000 C Manual De Usuario página 68

1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
Opening your life
1000 P
RO
E. CONFIGURATION OF THE MAINTENANCE ALARM CYCLE COUNTER
a) Hold down the SET button until "1" appears on the display, then to enter this
function setting press the UP button until "E" appears on the display and then
release the button.
b) Press the SET button again. The unit is now in the maintenance alarm setting
mode. Then you will see a "0" gure on the screen, with a ashing dot.
c) Press the UP / DOWN button, you can select the operating cycles you need for
the opening motor to notify you. You can choose between "1-5".
Figure "1" means that after the garage door has worked 1000 times, the LED light
will ash rapidly 10 times after the door stops working. To notify that your garage
door needs maintenance and at the same time you will see a "t" gure on the
screen.
Figure "2" means that the maintenance alarm count cycle is set to 2000 times.
Figure "3" means that the maintenance alarm count cycle is set 3000 times.
Figure "4" means that the maintenance alarm count cycle is set 4000 times.
Figure "5" means that the maintenance alarm count cycle is set 5000 times.
d) Press the SET button to con rm the setting, it will automatically return to the
standby state and an "II" will be displayed.
Note:
1. Counting cycle operation is set to "0" as standard at the factory.
F. OPEN / STOP / CLOSE TERMINALS
The O / S / C function can be used as an external switch to operate the opening
motor. The switch should have voltage-free normally open contacts.
Opening your life
27