Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Briggs & Stratton Generac Generator Discount Parts Call 606-678-9623 or 606-561-4983
INSTALL WHEEL KIT
The wheel kit is designed to greatly improve the portability
of your generator.
NOTE: Wheel kit is not intended for over-the-road use.
You will need a 1/2" or 13mm socket wrench, a 1/2" or
13mm open end wrench, a 7/16" socket wrench, 7/16" open
end wrench and a needle-nose pliers to install this kit.
NOTE: Adjustable wrenches may be substituted for open
end wrenches.
Refer to Figure 2 and install the wheel kit as follows:
1.
Place the bottom of the generator frame on a flat, even
surface.Temporarily place unit on blocks to ease assembly.
2.
Slide axle through both axle mounting brackets on
cradle frame, as shown in Figure 2.
3.
Slide a wheel over the axle.
Figure 2 — Install Wheel Kit
7500W Portable Generator
Axle
www.mymowerparts.com
NOTE: Be sure to install both wheels with the air
pressure valve on the outboard side.
4.
Slide a flat washer over the axle and place the e-ring
onto the groove in the axle.
5.
Place one end of the needle nose pliers on the bottom
of the axle and the other end of the pliers on top of
the e-ring. Seat the e-ring by pressing the pliers closed.
6.
Repeat step 3 through 5 to secure second wheel.
7.
Remove the temporary blocks.
8.
Attach vibration mounts to support leg with M6-1.0 x
16 capscrew and M6 lock nut.
9.
With wheels on, secure support leg assembly to cradle
with M8 x 20 mm long capscrews, flat washers, and
lock washers.
10. Check that all fasteners are tight and the tires are inflated
to the value marked on the tire or within 15 and 40 psi.
Vibration Mount
Cap
Wheel
Screw
Flat Washer
E-Ring
7
Hex Nut
Support Leg
Flat Washer
Lock Washer
Cap Screw
Capítulos
Tabla de contenido
