Error Messages - Wetrok Duomatic Laser 65 Instrucciones De Manejo

Error messages

E D
Error message
F001
R F
F002
F003
F004
I T
F013
F020
S E
F030
All further error messages
"STOP" displayed
N E
"CALL" displayed
F I
L N
V S
A D
L P
T P
R T
R A
c h t s e u D
Description
Battery voltage too low
i s ç a a n F r
Battery flat
Excess temperature, power electronics
Foam sensor
o n l i a I t a
Drive motor overheating
Excess current to brush motor
o l a ñ p E s
Excess current to suction turbine
Drive stop activated
s h g l i n E
Time for service inspection
(Only appears if activated by service personnel)
m i o u S
d s a n e r l d e N
k a n s v e S
s k a n D
i s k o l P
s u ê g t u o r P
ç e r k T ü
Steps to be taken
- Charge battery as quickly as possible
- Check battery, replace if necessary
- Charge battery as quickly as possible
- Check battery, replace if necessary
- Allow machine to cool off
- Activate machine reset (key switch off/on)
As far as foam does not collapse by itself and the error message goes
out:
- Empty tank, allow foam to collapse
- Allow machine to cool off
- Activate machine reset (key switch off/on)
- Activate machine reset (key switch off/on)
- Reduce brush pressure level
- Activate machine reset (key switch off/on)
- Search for clogging in suction nozzle, suction hose and air suction
point and remove obstruction
- Activate machine reset (key switch off/on)
- Unlock drive-stop switch
- Inform service representative
3