GB
•
Make sure that the spring chuck diameter is the same as the axle diameter of the accessory.
•
Use a clamping device for securing the work piece.
•
Keep your hands away from the work piece.
Electrical safety
When using electric machines always observe the safety regulations applicable in your
country to reduce the risk of fire, electric shock and personal injury. Read the following safety
instructions and also the enclosed safety instructions. Keep these instructions in a safe place!
Always check that the power supply corresponds to the voltage on the rating plate.
Class ll machine. Your machine is double insulated; therefore no earthwire is
required.
Replacing cables or plugs
If the mains cable becomes damaged, it must be replaced with a special mains cable available
from the manufacturer or the manufacturer's customer service. Dispose of old cables or plugs
immediately after replacing them with new ones. It is dangerous to connect the plug of a loose
cable to a socket.
Using extension cables
Only use an approved extension cable suitable for the power input of the machine. The
minimum conductor size is 1.5 mm
completely.
3. ASSEMBLY OF ACCESSORIES
Assembly of accessories
Fig. 1
Before assembly always remove the plug from the mains.
Warning! Change accessories by inserting an accessory into the collet (or chuck)
as far possible to minimize run out and unbalance.
Press down the axle locking button (2) and hold it down. Using the spring chuck spanner you
can undo the spring chuck (1). Put the accessory in its place. Hold down the axle locking
button when you fasten the spring chuck with the spring chuck spanner.
Operation
Switch on the machine by engaging the on/out switch (A) By adjusting the adjusting wheel (B) you
can regulate the speed of the Combi tool. Do not put the machine down when the motor is still
running. Do not place the machine on a dusty surface. Dust particles may enter the mechanism.
06
2
. When using a cable reel always unwind the reel
CE
KONFORMITETSERKLÆRING (DK)
er i overensstemmelse med følgende standarder eller normative dokumenter:
EN50144-1, EN50144-2-3, EN55014-1, EN55014-2, EN61000-3-2, EN61000-3-3
98/37/EC, 73/23/EEC, 89/336/EEC, 2002/95/EC, 2002/96/EC
Frå 01-01-2007
ZWOLLE NL
J.A. Bakker - van Ingen
CEO Ferm BV
Vores firmapolitik bygger på løbende forbedring af vores produkter, og vi forbeholder os retten
til at ændre produktspecifikationer uden varsel.
Ferm BV • Lingenstraat 6 • 8028 PM Zwolle • Holland
Ferm
Ferm
Vi erklærer under almindeligt ansvar, at dette
FCT160F
i overenstemmelse med direktivreglerne
Quality Manager Ferm Global
J. Lodewijk
DK
79