Model And Serial Number Location - Frigidaire FGEW276SPBB Instrucciones De Instalación

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS
Cable from Power Supply
White Wire
(Neutral)
Red
Wires
Ground Wire
(Bare or Green Wire)
Cable from appliance
Figure 2
3-WIRE GROUNDED JUNCTION BOX
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system. (see figure 3):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
connect appliance and power supply cable wires as
shown in Figure 3.
Cable from Power Supply
Ground
Wire
Red
Wires
Ground Wire
(Bare or
Green Wire)
Junction
Box
Cable from
appliance
Figure 3
4-WIRE GROUNDED JUNCTION BOX
(and Optional Electric or Gas Cooktop Combination)
Black
Wires
Junction
Box
White Wire
(Neutral)
U.L.-Listed Conduit
Connector (or CSA
listed)
White
Wire
Black
Wires
White Wire
U.L.-Listed
Conduit
Connector (or
CSA listed)

5. Model and Serial Number Location

The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
6. Oven Door Opening Reversal
Procedure
This wall oven can easily be modified to a left or a right
hand opening. When you receive your appliance the
door is set for a left opening. It is preferable to reverse
door opening prior to the installation of the wall oven
into the cabinet cavity. If wall oven is already installed,
removed the anti-tip screws and then pull wall oven
outward by approx. 2" (5 cm).
6.1 To remove the oven door from the
appliance
Be sure the oven door is closed.
6.1.1. Unscrew and remove the threaded pin from the
lower hinge (See A, Figure 5).
4
Wall Oven
Serial Plate
Location
Figure 4
Figure 5