Haier HCR2250AES Instrucciones De Instalación página 20

NOTE: Allow enough slack to connect the wires to the terminal block.
a
b
c
a
Terminal Block
b
Jumper Wire
c
Ground Screw
d
Power Cord Wires
5. Remove the ground screw. Place the green ground wire from the conduit on top
of the green ground wire from the range, replace screw and tighten.
6. Using 10-32 hex nuts, connect the red and black wires from the conduit to the
outer posts of the terminal block with the corresponding red and black wires
from the range.
7. Tighten the hex nuts completely, and then verify the connection.
8. Position the back panel against the back of the range, but do not fasten.
9. Gently, pull the excess conduit to the outside.
10. Position the lower part of the strain relief under the conduit and tighten the
strain relief screws.
NOTE: Before tightening, make sure the strain relief is positioned over the
conduit and NOT the wires.
11. Replace the back panel screws, and then fully tighten the screws.
12. Tuck excess conduit under the range.
18
e
Strain Relief Nut
f
UL Listed Strain Relief
g
Back Panel
a
a
b
b
Strain Relief
Screws
Lower Part of
Strain Relief
d
e
f
g