Optional Accessories (Sold Separately); Basic Functions; Battery Removal/Installation - HIKOKI GP 10DL Instrucciones De Manejo

OPTIONAL ACCESSORIES (sold separately)

1. Battery (BCL1015)
Optional accessories are subject to change without notice.
APPLICATIONS
○ Making wood carved handicrafts and precious metal
ornaments
○ Engraving and sculpting glass and ceramics
○ Grinding and polishing steel and stone

BASIC FUNCTIONS

1. Low battery warning lamp (Fig. 1)
To check the remaining battery power, operate the
grinder unloaded.
If the remaining battery power is low, the warning lamp
(red LED) will light. If the lamp lights, charge the battery
without delay.
NOTE
○ The low battery warning lamp may be aff ected by the
ambient temperature or battery characteristics. Use
the lamp as a guide for when to charge the battery.
○ The low battery warning lamp may light during operation
of the grinder. This is due to a temporary drop in the
battery voltage, and not to low battery power.
○ When checking the remaining battery power, be sure
to operate the grinder in an unloaded condition.
Before
charging
While
charging
Charging
pilot lamp
complete
(red)
Overheat
standby
Charging
impossible
Indications of the pilot lamp
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Blinks
Lights continuously
Lights
Lights for 0.5 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Blinks
Lights for 1 seconds. Does not light for
0.5 seconds. (off for 0.5 seconds)
Blinks
Lights for 0.1 seconds. Does not light for
0.1 seconds. (off for 0.1 seconds)
Flickers
2. Switch dial
The switch dial also serves as the start-up switch and
the speed dial. When the dial is rotated from [0] to a
higher number, the grinder switches on and gradually
builds up speed. At the same time, the LED lamp lights
and illuminates the tip of the grinder.
When the dial is returned to [0], the grinder switches off
and rotation stops.
For safety reasons, the grinder will not start up if the
battery is inserted while the switch is at any position
other than [0].
To switch the grinder on at such time, return the dial to
[0] and then rotate it to a higher number.
The approximate relationship between the numbers on
the switch dial and the rotation speed is shown in the
graph in Fig. 2.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latch to
remove the battery (see Figs. 3 and 4).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 4).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to a receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1-second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger till it contacts
the bottom of the charger as shown in Fig. 5.
3. Charging
When inserting a battery in the charger, the pilot lamp
will light up continuously in red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1, according to the condition of the charger or
the rechargeable battery.
Table 1
English
Battery overheated.
Unable to charge
(Charging will commence
when battery cools).
Malfunction in the
battery or the charger
11