Unold 68801 Instrucciones De Uso página 28

11. The axle of the mixing unit must
be inserted into the hole on the
front side of the motor block.
The two recesses and the bottom
holes in the mixing unit must cor-
respond exactly with the motor
block (Fig. 7).
12. Hold the lid upright on the mix-
ing container and make sure that
the two projections on the lid fit
into the recesses on the front side
of the motor block. Press the lid
down until it locks into place on
the mixing container (Fig. 8).
13. Important: The sealing cover must
audibly lock into place, since this
activates the safety switch; oth-
erwise, the appliance cannot be
switched on. In case the cover
does not lock into place, check
whether the mixing container was
inserted correctly.
14. Now insert the desired pasta
extruder disc in the sealing ring.
Turn the sealing ring clockwise
onto the threads of the front cover
until it is tight (Fig. 9). Tighten
the sealing ring only by hand. You
can use the included wrench to
loosen the ring.
15. To disassemble the appliance,
perform the above steps in reverse
sequence.
28
Copyright UNOLD AG | www.unold.de
Fig. 7
Fig. 8
Fig. 9