Campbell Hausfeld TL146200AJ Manual Del Operador página 7

Preparation
(Continued)
mAnuAl lubricAtion
If an air line lubricator is not used, the
tool must be lubricated daily.
supply bEfORE lubricating. failure to
disconnect the air supply from the tool
COULD result in death or serious injury.
1. Disconnect the air tool from the air
supply.
2. Turn the air tool upside down.
3. While pulling the trigger, squeeze
approximately a 3 to 5 drops of
Campbell Hausfeld airtool oil in the
air inlet. See Figure 3.
lubricated, oil will discharge through
the exhaust port during the first few
seconds of operation. The exhaust port
must be directed away from your body
before applying air pressure.
4. Connect the air tool to the air supply
and cover the exhaust port with a
towel. Ensure operating pressure at
tool does not exceed 90 PSI. Run
the tool for 10 to 15 seconds. Oil will
discharge from the exhaust port when
air pressure is applied.
how to change accessorIes
Disconnect your multi-function oscillating
tool from air supply. Press firmly down on
tool free attachment lever. See Figure 4.
Using your other hand, slide in accessory
to desired position. Make sure accessory
is securely seated on arbor before
operating.
Disconnect the
air tool from the air
After an air tool
has been
www.campbellhausfeld.com
Tl146200AJ and Tl146299AJ
Oil (not
included)
Figure 3 - lubricate the air motor
Figure 4 - changing Accessories / using tool
Free Attachment
Air Inlet
7