Using The Appliance - Unold 48241 Instrucciones De Uso

Ocultar thumbs Ver también para 48241:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 53
turing residues. Make sure the
room is well ventilated during this
process. After the initial heating
process the appliance might show
signs of wear, which do not affect
its features and do not constitute
a reason for rejection.
4.
Before first use, slightly grease
both waffle plates with heat resis-
tant grease like margarine, for

USING THE APPLIANCE

1.
Place the batter – best with a
scoop – in the middle of the lower
baking plates. When the appli-
ance is closed, the batter spreads
out uniformly. If you fill with too
little batter, the upper part of the
appliance does not lie properly;
the upper side of the waffle will
then not become as brown as
the lower side. If you fill with too
much batter, the batter runs out
and soils the appliance.
2.
Close the appliance immediately
after filling with batter, so that the
waffles will become equally brown
above and below.
3.
A few seconds after the batter has
been filled, the control lamp turns
on; the baking process begins.
4.
The desired degree of browning
can be achieved with the con-
tinuously adjustable temperature
regulator. With a low setting, you
obtain lighter and with higher set-
20
Copyright UNOLD AG | www.unold.de
example, using a pastry brush (as
the waffle plates are non-stick
coated, greasing is only necessary
before the very first use).
5.
The appliance may generate a
slight smell when first using it,
which is absolutely normal.
6.
The first waffle should not be used
and should be thrown away.
ting darker waffles. All degrees of
browning are in the continuous
intermediate range.
5.
When the baking process has been
completed, the control lamp swit-
ches off and shows, that the waff-
les are ready. The heating is inter-
rupted. If the waffles are too light
choose a higher baking setting, if
they are too dark, choose a lower
setting.
6.
After removal of the waffle, the
appliance can immediately be
filled again with batter. The con-
trol lamp turns on again. Continue
until all of the batter has been
used.
7.
After baking, unplug the appli-
ance. It is not switched off until
disconnected from the mains.
Attention: After disconnecting,
the appliance is still very hot
for some time!
Tabla de contenido
loading

Tabla de contenido