Operation; Requirements At The Place Of Use; Adjusting The Clipping Pressure - Heiniger Xperience/D Manual De Instrucciones

6 Operation

6.1 Requirements at the place of use

• Observe the operating instructions (see chapter Specifications).
• Outdoor electrical sockets must be fitted with a residual current device (RCD).
• The work place must have adequate lighting.
• The electrical socket must be easily accessible so that the device can be quickly
disconnected from the mains.
• The cable must not be taut or kinked.
• Make sure there is adequate ventilation.

6.2 Adjusting the clipping pressure

Fig. 3
► If the clipping pressure is too low, hair can gather between the clipping blades. This
results in a poor clipping quality. In this case, clean the clipping blades as described in
chapter 6.7.
28
Set the clipping pressure as follows before you start
clipping:
Turn the adjusting knob in the direction of the
‹
arrow until you feel resistance.
Turn the knob another 1/4 turn in the direction
‹
of the arrow.
If the clipping quality deteriorates, increase the
‹
clipping pressure by turning the adjusting knob
another 1/4 turn in the direction of the arrow.
If this does not produce the desired result, the
blades must be replaced or sharpened.
NOTE
Cattle clipper Xperience