Lavorwash THERMIC 9 Manual De Instrucciones página 18

5. Trigger the gun to eliminate trapped air, wait
for a steady flow of water to emerge from the
spray nozzle (fig. 9).
fig. 9
ACAUTION! In order to assist the first startup,
it is recommended to hold the trigger pressed
during the pulling of the starter handle
6. Push the fuel cock to ON position (Fig. 10).
ON
7. Push the choke lever to the OFF position OFF
(Fig. 11).
CLOSE
NOTE
Do not the choke if the engine is warm or
the air temperature is high.
8. Start the engine (Fig. 13).
Engine
switch
ON
fig. 13
a) Push the engine switch to the ON position.
b) Pull slightly the starting rope handle up until
feeing anti-action, and then make
CAUTION
Return the starting rope handle gently to prevent
18
damage to the starter.
9. Preheat the engine and push back the choke
lever to "OPEN" (Fig.14).
II. STOP
"OFF" to stall the engine. Stop it in normal in the
following sequence:
Fuel cock
1. Push the engine switch to the OFF position
(Fig. 15).
ON
fig. 10
Chock lever
2. Set the fuel cock to the OFF position (Fig. 16).
OFF
fig. 11
finished working.
Starting rope off, always discharge the pressure hose, opening
the gun.
handle
MAINTENANCE
maintenance to the washer machine, run the
pressure down, take the water connection out.
a
rapid pull. Motor: see "owner's manual - general gasoline
engine".
Choke lever
In an emergency, push the engine switch to
OFF
fig. 15
Fuel cock
OFF
fig. 16
CAUTION: Turn off the machine when
CAUTION: When the machine is switched
CAUTION: Before to carry out any kind of
OPEN
fig. 14
we recommend