Beurer HL 70 Manual De Instrucciones página 15

Note
• Batteries do not have their full load capacity from the beginning. In order to achieve the
full load capacity of the batteries, they should be fully charged, completely discharged
and then fully charged once more prior to initial operation of the device. This recharge/
discharge cycle should be repeated as often as possible to extend the service life of the
batteries.
• The epilator can be used on dry or wet hair.
• When used on dry skin, the skin must be completely dry and free from grease.
• When used on wet skin, it is important that the skin is sufficiently damp so that the device
can glide optimally over the skin. Epilating is easiest after a shower or bath.
• Do not use any cream before epilating.
• Epilation is easier and more comfortable if the hairs are at the optimal length of 2-5 mm.
If the hairs are longer, we recommend that you first shave the area and after 1-2 weeks
epilate the shorter regrowth.
• Thoroughly clean the epilator attachment before epilating. This reduces the risk of infection as
much as possible.
• Press the on/off button to switch on the device.
• Press the button again to increase the speed.
• The "Epilight" function ensures optimal lighting conditions so that you can see and remove
even the finest hairs.
• Hold the skin taught with your free hand to help lift the hairs.
• Move the device slowly, steadily and without pressure over the skin, with the "Epilight" side
pointed against the direction of hair growth. Make sure you hold the device vertically at a 90°
angle to the skin. As hair doesn't always grow in one direction, it can be useful to move the de-
vice in various directions over the skin to achieve an optimal result.
• Be aware that the underarm and bikini areas may be particularly sensitive to pain at first. We
therefore recommend that you use the lowest speed setting for the first use. The pain will les-
sen with repeated use. As skin in this area is particularly sensitive after epilation, do not use
any substances that might irritate the skin such as alcohol-based deodorant.
Changing the attachment:
• To replace an attachment, press the unlock button and take the epilator
attachment off the device.
• Place the corresponding attachment back on the device, ensuring that it
clicks into place.
• Can only be attached in one direction.
• To change the shaver or exfoliation attachment, remove the attachment from
the attachment holder and then reinsert the attachment you wish to use.
Note
We recommend that you use the shaver attachment on the second speed set-
ting to achieve optimum results.
15