Final Setup; Care And Maintenance - Heath Zenith 4151 Instrucciones De Instalación Y Operación

Final Setup

1. Adjust the sensitivity (SENS) to increase or decrease
the range as needed. Too much sensitivity may cause
false triggering due to heat sources in the coverage area
(see Testing and Adjustments or Troubleshooting section).
2. Set the amount of ON-TIME you want the light to
stay on after motion is detected (1, 5, or 10 minutes).
3. Set the DualBrite® switch to off, 3 hours, 6 hours,
or dusk-to-dawn.
4. Caulk around fixture base with silicone weather seal-
ant after all Testing and Adjustments are complete.
Caulking Around Fixture Base
Operating Modes
Mode: On-Time
Test
5 Seconds
Auto
1, 5, or 10 Minutes
Accent
3, 6 Hour, To Dawn
Manual
To Dawn*
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.
• Motion Sensor (AUTO) – This light fixture is designed
to automatically turn on when the sensor detects a tem-
perature difference moving across the front of the motion
sensor. The light will turn off automatically after a set
amount of time. The ON-TIME control should be set
to 1, 5, or 10 minute setting and the wall switch should
be left in the ON position at all times.
204030-03
Works: Day Night
x x
x
x
x
/ minutes for
1
2
• Optional DualBrite® Control – This optional feature
allows the light fixture to turn on at a lower light level
after dusk (sunset) for the amount of time selected. When
motion is detected, the lights will turn on full bright. This
feature can be turned OFF and the motion sensor will
continue to work in AUTO mode.
• Manual Mode – This light can be activated to stay on full
bright after dusk (sunset) for only one night at a time. It
automatically resets to motion sensing at dawn (sunrise).
Manual mode must be re-activated each night. Note: If
power to the light fixture is off for more than 5 seconds,
allow the electronic circuitry in the sensor to calibrate
(90 seconds) prior to switching to manual mode.
1. To turn on MANUAL mode, switch the light off at
the wall switch for 1 to 2 seconds and then back on.
2. To return to AUTO mode, switch the light off at the
wall switch for 1 to 2 seconds and then back on.
Note: The sensor will also reset to AUTO mode at
sunrise.
Turn Switch OFF for
1 to 2 seconds

CARE AND MAINTENANCE

• To prolong the original appearance, clean with clear water
and a soft damp cloth only.
• Do not use paints, solvents, or other chemicals on this
light fixture. They could cause a premature deterioration
of the finish. This is not a defect in the finish and will not
be covered by the warranty.
• Do not spray with hose or power washer.
7
Turn Switch
Back ON