Honda HF2315 Manual Del Operador página 15

Clean the plastic parts of the body with a damp sponge using water
and detergent, taking care not to pu water on the engine, the electri-
cal parts or the electronic card located under the dashboard.
IMPORTANT
Never use hose-nozzles or harsh detergents for cle-
aning the body and engine!
When washing the inside of the cutting-means assembly and the
discharge chute, the machine must be on firm ground with:
– the grass catcher or the dis-
charge guard fitted in place;
– the operator seated;
– the engine running;
– the transmission in neutral;
– the parking brake - engaged;
– the cutting means engaged.
Connect a water hose to each of the pipe fittings (1) one at a time
and run water through each one for a few minutes, with the cutting
means moving.
When washing, the cutting-means assembly should be lowered right
down. Now remove the grass catcher, empty and rinse it, then place
it where it can dry quickly.
IMPORTANT
To avoid impairing the efficient working of the elec-
tromagnetic clutch:
– prevent the friction from coming into contact with oil;
– do not direct jets of high-pressure water directly onto the clutch
unit;
– do not clean the clutch with petrol.
5.4.12 Removing the belt guard and cleaning the cutting-
means assembly
WARNING!
Do not let debris and dried grass accumulate
in the upper part of the cutting-means assembly in order to
maintain maximum machine efficiency and safety levels.
This operation should be performed 2-3 times a year and
before storing the machine away for a period of time (by way
of example only, at the end of the season).
WARNING!
Your machine is fitted with two transmission
chain guards (one on the right and one on the left) to prevent
accidental contact during use.
HF2315 ♦•
◊
The left guard (1a) is fixed by:
– two nuts (2a), unscrew using a 10 mm key;
– a front screw (3a) and a central screw (3b), unscrew using a 10
mm key;
3a 2a 3b 2a
1a
The right guard (1b) is fixed by:
– two nuts (2b), unscrew using a 10mm key;
– a front screw (3c) and a central screw (3d), unscrew using a 10
mm key;
2b
NOTE
When removing the left guard (1a) make sure you
do not disconnect the hoses from the fitting used to clean the in-
side of the cutting-means assembly.
When remounting the left and right guards, replace all the nuts (2a)
and (2b) and then all the screws,
HF24•• ♦• HF26••
◊
The left guard (1c) is fixed by:
– two nuts (2c) and a front screw (3e), unscrew using a 10 mm key;
– a central screw (3f) with a spacer (4), unscrew using an 8 mm
key;
3e 2c
The right guard (1d) is fixed by:
– two nuts (2d) and a front screw (3g), unscrew using a 10 mm
key;
– a central screw (3h) with a spacer (4), unscrew using an 8 mm
key;
2d
When remounting the left and right guards, make sure the spacers
(4) are fitted correctly below the screws (3f) and (3h).
3d 2b
1b
♦•
◊
4
3f 2c
1c
4
3h 2d
1d
3c
3g
15 EN