Breaking-In The Engine - Efco DS 2400D-PU Manual De Instrucciones

in immediate vicinity which could come in
contact with the cutting attachment. Hold
the body of the machine on the ground
using your left hand (CAUTION! Not with
en
your foot!), see Fig. 7.
Start-up procedure
1) Slowly push the purge bulb 6 times (6,
Fig.1).
2) Pull the choke lever (12, Fig.1) in the
CLOSE position
it also activates automatically half-throttle.
3) Place the power unit on the ground in a
stable position. Check that the cutting
attachment is free. Holding the power unit
down (Fig.7), pull the starter rope until the
first kick over of the engine is heard (no
more than 3 pulls). A new unit may require
additional pulls.
4) Push the choke lever (12, Fig.1) in OPEN
(I) position (B, Fig.8).
5) Pull the starter cord to start the engine.
Once the machine is started, warm up the
machine for about few seconds, without
touch the throttle lever. The machine could
need more seconds to warm up with cold
weather or at high altitudes. Finally, put the
choke lever (15, Fig.1) for deactivate the
automatic half-throttle.
CAUTION:
- Never wrap the starter cord
around your hand.
- When pulling the starter rope,
do not use the full extent of the
rope as this can cause the rope
to break.
- Do not let starter rope snap
back. Hold the starter handle
(11, Fig.1) and let the rope
rewind slowly.
14
OPERATION
(A, Fig.8). In so doing,
WARNING: Do not cut material
with the choke lever at the
CLOSE position. Do not operate
your power unit with the starting
throttle lock engaged. Cutting with
the starting throttle lock engaged
does not permit the operator
proper control of the power unit.
NOTE - STARTING WARM ENGINE:
Follow above starting instructions, but do
not use the CLOSE position for start up
again.
WARNING: Weather conditions
and altitude
carburetion.
bystanders close to the power unit
while adjusting the carburetor.
Keep the engine at full throttle the entire time
you are cutting.
NOTE: It is normal for smoke to be emitted
from a new engine during and after first
use.

Breaking-in the Engine

The engine reaches the maximum power
after 5-8 hours of activity.
During this period of breaking-in do not make
the machine function idly at full throttle, to
avoid excessive functioning stress.
CAUTION! – During the breaking-
in period
carburetion to obtain a presumed
power increment; the engine can
be damaged.
may affect
Do not allow
do not vary the