Electric Lock Activation Time - Fermax VDS / BUS2 Manual De Instalador Y Programación

DIRECT VDS - B DIRECT DIRECT DIRECT DIRECT VDS - B VDS - B VDS - B VDS - BUS2
DIRECT DIRECT VDS - B VDS - B
DIRECT DIRECT VDS - B DIRECT VDS - B VDS - BUS2

1.2.- ELECTRIC LOCK ACTIVATION TIME

This parameter can be set up by software programming using the panel
keypad (there is no need to open the outdoor panel).
System allows two different electric lock activation times:
- Door activation from house terminal (monitor and telephone) and the
outdoor panel (using the access control feature):
- Another one related to the door open pushbutton (inside the building) if
it is installed.
There are two simple steps to program the electric lock activation time:
1.- Power down and up the system (warm boot). There is only a minute to
do the following steps.
2.- Enter programming code (3 1 4 1) to enable programming mode and
four digits:
a. First two digits to set up the activation time related to the dwellings
and outdoor panel.
b. Last two to set up the activation time related to the indoor open
pushbutton.
REMARKS:
Activation time range is 1-99 seconds.
Each time is defined by 2 digits, so every time less than 10 seconds must be
entered preceded by a '0'.
On error(-s) in programming process, sequence must be restarted from the
beginning (step 1).
DIRECT DIRECT VDS - B VDS - B
DIRECT VDS - B DIRECT DIRECT VDS - B VDS - BUS2
DIRECT DIRECT DIRECT VDS - B VDS - B VDS - BUS2 VDS - B
DIRECT DIRECT VDS - B
1.2.- ELECTRIC LOCK ACTIVATION TIME
This parameter can be set up by software programming using the panel
keypad (there is no need to open the outdoor panel).
System allows two different electric lock activation times:
- Door activation from house terminal (monitor and telephone) and the
outdoor panel (using the access control feature):
- Another one related to the door open pushbutton (inside the building) if
it is installed.
There are two simple steps to program the electric lock activation time:
1.- Power down and up the system (warm boot). There is only a minute to
do the following steps.
2.- Enter programming code (3 1 4 1) to enable programming mode and
four digits:
a. First two digits to set up the activation time related to the dwellings
and outdoor panel.
b. Last two to set up the activation time related to the indoor open
pushbutton.
REMARKS:
Activation time range is 1-99 seconds.
Each time is defined by 2 digits, so every time less than 10 seconds must be
entered preceded by a '0'.
On error(-s) in programming process, sequence must be restarted from the
beginning (step 1).
US2 US2 US2 US2
US2 US2
US2 US2
US2 US2
US2 US2
US2 US2 US2
US2
Pag 11
Pag 11