Fisher & Paykel RX256DT7X1-22600-A Instructivo De Instalacion Y Guia Del Usuario página 36

Refrigerador doble
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Ca e
and
deaning
Replacing
light b@bs
Electdc Shock Hazard
Disconnect power to refrigerator' before replacing _ight b@boAfter replacing
_ight b@b, reconnect power,
Failure to do so can res@t in death or injury to persons°
2
3
4
To avoid personal injury or property
damage, observe the following:
Altow light bulb to cool once refrigerator
has been turned
of£
Wear gloves
when replacing
light buibo
Upper fresh food
section
The upper fresh food light bulbs are located
behind the front
panel Reach behind the panel to remove the bulbs.
Lower fresh food section
Push up on bottom
tabs on light cover. Rotate cover up and
release tabs.
Remove light bulb.
Replace bulb with appliance
bulb no greater than 40 watts.
Insert top tabs of light cover into liner slots and snap bottom
tabs into liner slots.
Upper freezer section
1
Remove ice bin by lifting front of bin and pulling out.
2
Remove light shield by pressing the upper right side of the
shield and rotating
downward.
s
Remove light bulb. Replace with appliance
bulb no greater
than 40 watts.
4
Rotate the shield upward, press in slightly and snap into place.
5
Replace ice bin by sliding in until bin locks into place.
Fig.20 Light in lower
fresh food
ection
Fig.21Lights in upper
freezersection
Lower freezer
section
'I
Pinch both sides of light cover to remove.
2
Remove light bulb. Replace with appliance
bulb no greater
than 40 watts.
3
Pinch both sides of the light cover to snap into place.
Ice and water dispenser
'I
Locate light bulb inside top edge of dispenser frame. Unscrew
to remove.
2
Replace light bulb with a 7--watt, 120volt bulb.
- Light B@b
Location
<
Fig.22Iceond worer dispenser
Tabla de contenido
loading

Este manual también es adecuado para:

Rx256dt4x1Rx216dt4x1

Tabla de contenido