If aminor p roblem occurs, itusually can
besolved q uite easily when thecause is
found byusing thecheck listbelow.
b
•
O
=
_
=
•
Possible cause
Possible solution
• Not firmly plugged
in
• Plug unit in firmly
• No voltage
in wall receptacle
• Check fuse or breaker
• Blown fuse/tripped
breaker
• Replace fuse/reset breaker
Possible
cause
Possible
solution
2. Turn valve cap (A) counterclockwise
and remove.
Soak valve cap in warm water for at
least 15 minutes. Wipe cap dry.
• Recovery tank full/automatic
shut
off engaged
• Remove and empty recovery tank
• Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on correctly
• Make sure lid is on securely
• Water tank empty, but detergent
remains
• Fill water tank
Possible cause
Possible solution
• Clean water tank not firmly
in place
• Make sure tank is securely locked in
position
• Clean water tank or detergent
container
empty
• Refill container according
to instruc-
tions for surface being cleaned
• Recovery tank lid not on
correctly
• Make sure lid is firmly in place
Possible
cause
Possible
solution
3. Align slots (B) on cap with tabs (C) in
opening.
Turn cap clockwise to tighten.
Possible cause
Possible solution
• Dirty filter screen on bottom
of unit
• Clean screen as shown in Fig. 3-2
• SpinScrub
mode selector
on SPILL
PICK-UP.
• Slide mode selector to HARD
TERRAIN or CARPET TERRAIN.
HARD TERRAIN setting and hard
floor
brushes
used on carpet
For CARPET cleaning, use carpet
brush assembly (green bristles) and
set SpinScrub mode selector to
CA RPET TERRA IN.
Service
To obtain approved
HOOVER service
and genuine HOOVER parts, locate the
nearest Hoover Sales and Service
Center or Authorized Hoover
Warranty
Service Dealer (Depot) by:
• checking the Service section of
Hoover on-line at www.hoover.com
OR
• checking
the list of Sales and
Service Centers provided with this
cleaner OR
• checking
the Yellow Pages under
"Vacuum Cleaners - Household" OR
, calling 1-800-944-9200
for an
automated referral of authorized
service outlet locations (U.S. only).
Do not send your cleaner to Hoover in
Newton, Iowa for service, this will only
result in delay.
If further assistance
is needed, contact
the Hoover Consumer Response Center,
Phone: 330-499-9499.
In Canada, contact Hoover Canada,
Burlington, Ontario L7R 4A8,
Phone: 1-800-263-6376.
Always identify your cleaner by the
complete
model number when request-
ing information or ordering parts. (The
model number appears on the bottom of
the cleaner.)
• Valve cap clogged
• Remove and clean valve cap (see fol-
lowing instructions)
1. Remove clean water tank.
Continued
-P
17