Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Removab|e
brushes
Your cleaner is equipped with removable
brushes. Follow these directions for
changing
brush assemblies OFfor easy
cleaning.
To remove
brushes
Disconnect
cleaner from electrical
outlet.
To prevent possible leaking, remove
clean water tank and recovery tank. Set
tanks aside.
W
With handle in upright position, tilt
cleaner back until handle rests on the
floor.
Grab brush assembly and pull firmly.
The brushes can be cleaned under run-
ning water.
B
D
B
To replace
brushes
Align posts (A) on both ends of brush
assembly with slots (B) in cleaner hous-
ing.
Make sure that the square post (C) also
aligns with the square hole (D). Turn
brushes slightly until post fits easily into
hole.
Press brush assembly firmly to snap into
place.
Storage
Before storing:
® Empty clean water tank and let air
dry. Replace on cleaner.
® Unused detergent can be stored in
the detergent container.
® Empty recovery tank, rinse tank
and lid thoroughly
with clean water
and let air dry.
Allow brushes
and underside
of car-
pet cleaner
to air dry thoroughly
before storing
cleaner on a carpeted
or wood surface.
Do not store
cleaner
with
a full
clean
water
tank
in place.
Lubrication
The motor is equipped with bearings
which contain sufficient lubrication
for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricant
to motor bearings,
16
Tabla de contenido
