Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A
/,
Read "Before
you begin cleaning"
instructions
on page 10.
1. Attach hose and solution tube as
instructed in Figs. 3-12 to 3-14.
2. Place handle in upright position.
Agitator brushes
will not rotate while
handle is in upright position.
3. Fill clean water tank according
to
instructions for Figs. 2-9 to 2-12.
4. Fill detergent container with HOOVER
Carpet/Upholstery
Detergent according
to instructions
for Figs 2-13 to 2-15.
5. Attach tool to end of hose.
6. Hose length may require that machine
be placed at the top of the stairs to clean
upper half of stairway and at bottom of
stairs to clean lower half.
To prevent machine
from falling,
use
extra caution
when cleaning
on stairs.
Do not place cleaner on stairs.
Do not point tools toward
people or
pets.
7. Dry hands and plug cleaner into a
properly grounded
outlet.
8. Set Rinse Setting switch to WASH-
AutoRinse.
Turn cleaner ON.
Note: "Auto-rinse" and rinse are not avail-
able during tool use. The hose will only
dispense water mixed with detergent.
9. Pre-spray the carpeted
stair by hold-
ing the tool (A) or (B) about one inch
above the carpet and push it forward
while pressing the trigger (equals one
wet stroke).
10. Position tool against the riser and slightly
press it into carpet pile. Press the trigger
and pull the tool slowly over the carpet
(second wet stroke). Release trigger at end
of stroke.
U
1. Lift tool, and position it against riser.
Pull tool slowly
over carpet without
pressing trigger (dry stroke).
12. Overlap strokes by 1/2 inch to help
prevent streaking.
It is best to alternate wet and dry
strokes as described above. End with
more dry strokes to aid in faster drying
of carpet.
To avoid saturating carpet, do not use
more than 4 wet strokes
over any one
area. Always
end with dry strokes.
If additional
cleaning is necessary, wait
until the carpet is completely
dry before
using the tool again.
13. Empty recovery tank when the motor
sound becomes higher pitched and
there is a loss in suction (see "Automatic
shut-off", Fig. 2-6).
When finished cleaning, follow "After
cleaning" instructions on page 11 and
"After using tool" instructions on page 14.
Read "Before
you begin cleaning"
instructions on page 10.
Be sure to check the cleaning code on
your upholstery. Use your cleaner only
on upholstery
marked "W" or "W/S".
1. Attach hose and solution tube as
instructed in Figs. 3-13 to 3-16.
2. Place handle in upright position.
Agitator
brushes
will not rotate while
handle is in upright
position.
3. Fill clean water tank according
to
instructions for Figs. 2-9 to 2-12.
4. Fill detergent container with HOOVER
Carpet/Upholstery
Detergent according
to instructions
for Figs. 2-13 to 2-15. Do
not use hard floor cleaning
solution
when cleaning
upholstery.
5. Attach tool to end of hose.
Do not point tools toward
people or
pets.
6. Dry hands and plug carpet cleaner
into a properly
grounded
outlet.
7. Set Rinse Setting switch to WASH-
AutoRinse.
Turn cleaner ON.
Note: "Auto-rinse" and rinse are not
available during tool use. The hose will
only dispense water mixed with deter-
gent.
8. Gently press the tool onto the fabric.
Press the trigger and slowly pull the noz-
zle over the fabric.
9. Overlap strokes by 1/2 inch to help
prevent streaking.
Make additional strokes without pressing
the trigger to remove more moisture.
10. To clean in corners or creases, lift
the tool one-half inch from the fabric and
press the solution trigger.
11. Vacuum up the solution with the tool
without pressing the trigger.
12. For heavily soiled areas, it may be
necessary to repeat the cleaning
process. Make crisscrossing
strokes to
the original pattern; overlap each pass
(Fig. 3-24).
Make
no more
than
2 passes
with the
solution
or rinse
over
any one area to
prevent
over-wetting
and damage
to
fabric.
If additional cleaning is necessary, wait
until the upholstery is completely
dry
before using the tool again.
13. Empty recovery tank when the motor
sound becomes
higher pitched and
there is a loss in suction (see "Automatic
shut-off", Fig. 2-6).
When finished cleaning, follow "After
cleaning" instructions on pages 11 & 12
and "After using tool" instructions on
page 14.
Continued
-P
15
Tabla de contenido
