Waeco IU812 Instrucciones De Montaje página 24

Fitting the automatic charger and putting it into servicePerfectCharge IU812
NOTICE!
A
The IU0U automatic charger must be installed in a place that is
protected from moisture and humidity.
Make sure:
 The installation location is well ventilated.
 The installation surface is flat and sufficiently firm.
The air intake on the underside and the air outlet on the back of the
IU0U automatic charger must be kept clear.
To connect the IU0U automatic charger only use cables not longer
than 2 m with a cross section of 1.5 mm² or more.
➤ Fix the IU0U automatic charger with suitable screws at the desired place.
Use the Sie IU0U automatic charger's fixing holes.
➤ Fit wire sleeves to the ends of cables which you wish to connect to the
IU0U automatic charger (fig. 2 1, page 3).
➤ Use crimping tongs (fig. 2 2, page 3) and make sure the the wire
sleeves are fitted tightly (fig. 2 1, page 3).
➤ Connect the cables (fig. 3 1, page 3) to the two terminals on the front
side as follows:
– Positive terminal (fig. 3 2, page 3): red cable
– Negative terminal (fig. 3 3, page 3): black cable
➤ Connect the battery to the IU0U automatic charger:
– Positive terminal of the battery: red cable
– Negative terminal of the battery: black cable
➤ Connect the 230 V mains power cable to a 230 V socket.
✓ The IU0U automatic charger now charges the battery.
24
EN