Waeco PerfectView M170L Instrucciones De Montaje Y De Uso página 34

Mounting the monitor
7.3 Laying the system cable from the camera to the monitor
Note
I
Lay the camera cable so that should you need to remove the camera, you can
access the plug connection between the camera and the extension cable easily.
This greatly facilitates the disassembly.
➤ Lay the system cable for the camera inside the vehicle.
➤ Lay the system cable for the camera to the monitor.
➤ Connect the monitor connection cable to the system cable.
➤ Insulate the plug connection with the insulating tape supplied. Overlap every layer of
the insulating tape by one half of its width.
➤ Attach the cables securely in the vehicles to prevent tripping hazards. This can be per-
formed by using cable binders, insulating tape or gluing in place with adhesives.
Note
I
Only start sealing through-holes when you have completed all installation work
on the camera and have laid the required cable lengths.
7.4 Connecting the monitor to an electricity supply (fig. f, page 10)
The circuit diagram for the monitor can be found in fig. f, page 10.
No. Description
1 Monitor
2 13-pin DIN plug
3 Connection cable
4 13-pin DIN socket
5 12 V positive cable (red): Connection to the positive pole of the voltage source
6 Earth cable (black): Connection to the negative pole of the voltage source
7 6-pin DIN socket
8 Filter
9 Cable (green): Control input for the connection to the reversing lights
10 6-pin mini DIN plug
11 System cable
12 6-pin mini DIN socket
13 6-pin mini DIN plug
14 Camera
34
PerfectView M170L