Waeco PerfectView M170L Instrucciones De Montaje Y De Uso página 28

Safety and installation instructions
If you disconnect the negative terminal of the battery, all data stored in the volatile
memories will be lost.
The following data must be set again, depending on the vehicle equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate operating
instructions.
Observe the following installation instructions:
Secure the monitor in such a way that it cannot become loose under any circumstances
(sudden braking, accidents) and cause injuries to the occupants of the vehicle.
Do not attach the monitor in the air bag deployment path, as this could cause injury if
the airbags are triggered.
To prevent damage, when drilling ensure that there is sufficient space on the other side
for the drill head to come out (fig. 2, page 4).
Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 1, page 3) or a voltmeter (fig. 1 2, page 3).
Test lamps with an illuminant (fig. 1 3, page 3) consume voltages which are too high
and which can damage the vehicle's electronic system.
When making electrical connections (fig. 3, page 4), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection
Insulate all connections.
Secure the cables against mechanical wear with cable binders or insulating tape,
for example to existing cables.
Observe the following instructions when handling the LCD monitor:
Do not open the monitor (fig. 4, page 4).
Do not submerge the monitor in water (fig. 5, page 4); the monitor is not waterproof.
The monitor must not impair your vision when driving (fig. b, page 7).
Do not use the monitor when you are driving.
Do not operate the monitor with wet hands.
Do not operate the monitor if the housing has been damaged.
Connect it to the correct voltage.
28
PerfectView M170L