Idiomas disponibles
Idiomas disponibles
ADjuST lANDiNG PAD PoSiTioNS THEN TiGHTEN THEM DoWN.
• using your control tower
instruction as a reference,
carefully place a bar and
towers assembly onto the
landing pads.
• Align position of landing
pads to allow the control
towers to fully close.
• center cross bars and attach
control Towers to cross bars
according to control Tower
instructions.
NoTe: Due to manufacturing variations the fastening hardware may bottom out in the hardpoint before the landing pad is fully tight.
if you encounter this situation, go back to step 6 and re-install with additional metal washer(s) (up to 3) to take up the slack.
READ THESE WARNINGS!
Be sure all hardware is secured according to instructions.
Make sure Control Towers,
with bars installed, seat
completely with Landing
Pad. If they do not seat
properly, repeat step 7.
Continue with Control Tower installation.
1033512H-4/28
Failure to perform safety checks before driving away can
result in property damage, personal injury, or death.
Attachment hardware can loosen over time. Check and
tighten if necessary, before each use.
To avoid damage your vehicle's finish remove and clean
Landing pads and mounting points periodically as road
sediment will accumulate over time.
• Open one Control Tower cover and
lift it up while opposite tower is still
engaged.
• While holding Control Tower above
landing Pad, fully tighten landing
Pad with long handle as shown. Do
NoT ovER TiGHTEN AS DAMAGE
To RooF MouNTiNG PoiNTS MAy
occuR.
• Repeat the process again for the
other landing Pads to ensure they
have not changed position.
• Re-insert control Tower into
landing Pad, fully tighten tower and
close cover(Control Towers Step 8).
Do NoT EXcEED MAXiMuM WEiGHT
LIMIT FOR YOUR VEHICLE (SEE ATTACHED
FiT cHART, yAKiMA FiT liST, coNTAcT
YOUR DEALER, OR CONTACT YAKIMA).
To see Weight limits for your vehicle, or load limitations for
accessories, check the yakima Fit list, contact your yakima
dealer, or visit www.yakima.com, or call (888)925-4621
Remove your YAKIMA rack and accessories
before entering automatic car washes.
Monday through Friday,
7:00 AM to 5:00 PM, PST
