FCC RADIATION EXPOSURE STATEMENT
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users must
follow the specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
CLASS 2 LASER SAFETY STATEMENT
This laser device complies with International Standard IEC/EN 60825-1: ED 2. 2007, Class 2 Laser
Product and also complies with 21 CFR 1040.10 and 1040.11, except for deviations pursuant to
laser Notice No. 50, dated June 24, 2007:
1. Emission of a parallel beam of visible light;
2. Maximum Power of 1 milliwatt CW, wavelength range 650±10 nanometers;
3. Operating temp between 0 ° C (32° F) to 40° C (104° F).
• Do not disassemble the device
650+/- 10nm
• Do not use the device outside of its specified operating temperature range. If the device is
exposed to an environment outside of its prescribed operation, turn off the device and allow the
temperature to stabilize within the specified operating range before using the device.
CAUTION!
A set of warning labels in different languages is provided with this product. It is essential
that the correct country-specific warning label is applied to the laser pointer for the safety
of the user and of the people nearby.
CAUTION!
This device has no serviceable parts. Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, Pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
R eorient or relocate the receiving antenna.
•
I ncrease the separation between the equipment and receiver.
•
C onnect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
C onsult the dealer or an experienced radio/TV technician for help.
MODIFICATIONS: Modifications not expressly approved by Kensington may void the user's authority to operate the device
under FCC regulations and must not be made.
Operating Frequency Range :2412-2472MHz
FCC DECLARATION OF CONFORMITY COMPLIANCE STATEMENT
This product complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) This device must accept any interference received, including interference
that may cause undesired operation. As defined in Section 2.909 of the FCC Rules, the responsible party for this device is
Kensington Computer Product Group, 333 Twin Dolphin Drive, Redwood Shores, CA 94065,USA.
INDUSTRY CANADA CONFORMITY
This Class B digital apparatus complies with Canadian ICES-003.
This device has been tested and found to comply with the limits specified in RSS-210. Operation is subject to the following
two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including
interference that may cause undesired operation of the device.
CE DECLARATION OF CONFORMITY
Kensington declares that this product is in compliance with the essential requirements and other relevant provisions of
applicable EC directives.
For Europe, a copy of the Declaration of Conformity for this product may be obtained by clicking on the Compliance
Documentation link at www.support.kensington.com
8
THE FOLLOWING INFORMATION IS ONLY FOR EU-MEMBER STATES:
The use of the symbol indicates that this product may not be treated as household waste. By ensuring this product
is disposed of correctly, you will help prevent potential negative consequences for the environment and human
health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed
information about recycling of this product, please contact your local city office, your household waste disposal
service or the shop where you purchased the product.
Kensington and the ACCO name and design are registered trademarks of ACCO Brands. The Kensington Promise is a service
mark of ACCO Brands. Presenter Expert is a trademark of ACCO Brands. All other trademarks are the property of their
respective owners.
© 2012 Kensington Computer Products Group, a division of ACCO Brands. Any unauthorized copying, duplicating, or other
reproduction of the contents hereof is prohibited without written consent from Kensington Computer Products Group. All
rights reserved. 09/12
Français
ATTENTION ! CONSIGNES DE SÉCURITÉ IMPORTANTES
Le présenteur avec laser rouge Presenter Expert™ inclut un pointeur laser intégré. Par
conséquent, comme lors de l'utilisation de n'importe quel pointeur laser, il est important
de respecter les avertissements et les consignes de sécurité suivants afin d'éviter tout
dommage :
•
N e dirigez jamais le pointeur laser dans les yeux d'une personne et ne fixez pas directement le rayon laser. Si vous
dirigez un pointeur laser dans les yeux de quelqu'un ou si vous fixez directement le rayon laser, vous risquez d'être
victime d'une altération temporaire de la vue (aveuglement par flash, désorientation ou éblouissement). Ceci peut
être particulièrement dangereux si la personne exposée effectue une activité où la vue est importante (la conduite,
par exemple). En outre, une exposition répétée et/ou prolongée au rayon laser peut être dangereuse et nocive pour
les yeux.
•
N e dirigez jamais un pointeur laser sur une personne ou un animal. Les pointeurs laser sont conçus pour illustrer
des objets inanimés uniquement. Dans certains états et provinces, il est illégal de diriger un pointeur laser sur un
officier de police ou toute autre personne. L'acheteur/utilisateur doit s'assurer de la conformité du pointeur laser aux
réglementations locales.
•
N e dirigez pas un pointeur laser sur des surfaces réfléchissantes telles que des miroirs. Un faisceau réfléchi peut agir
comme un faisceau direct dans les yeux.
•
L es pointeurs laser ne sont pas des jouets. Ne les laissez pas à la portée des enfants. Dans certains états et provinces,
il est illégal pour un mineur d'acheter et/ou d'utiliser un pointeur. L'acheteur/utilisateur doit s'assurer de la conformité
de l'achat ou de l'utilisation du pointeur laser aux réglementations locales.
Assistance technique
Une assistance technique est disponible pour tous les utilisateurs de produits Kensington enregistrés. L'assistance
technique est gratuite sauf en cas de déplacement longue distance, selon les tarifs applicables. Les coordonnées de
l'assistance technique sont disponibles au dos de ce manuel.
Conseils d'assistance technique
•
I l se peut que vous trouviez une solution à votre problème dans la Foire aux questions (FAQ) de la rubrique Assistance
du site Web de Kensington :www.support.kensington.com.
•
Vous devez avoir accès à votre périphérique lorsque vous appelez l'assistance technique.
•
L es informations suivantes vous seront demandées :
- Nom, adresse et numéro de téléphone
- Nom du produit Kensington
- Symptômes du problème et faits qui en sont à l'origine
9
