22
INSTALL THE DITCH MOLDING PIECES.
Firmly press the ditch molding into place. In
some cases an adhesive may be necessary.
23
ASSEMBLE THE PAD TO THE BASE.
STEPPED PAD
24
A
B
B
2º
2º
Instruction #1035971B - Page 7 of 15
FLAT PAD
A. Place a Landing Pad over each
bracket making sure the embossed
arrows on the Landing Pad face
outboard.
B. Select longest length of fasteners
that will not bottom out. Guide
the fasteners through the Landing
Pad, and into the threaded
mounting points on the bracket.
The pad has 4º of toe adjustment
to fine tune the position on curved
roofs.
C. Use the 5mm hex wrench to
tighten the hardware but do not
tighten completely.
D. Jostle and rotate the Landing Pad
in all directions to ensure it is snug,
yet allows for a small amount of
adjustment to prepare for final
alignment and tightening in the
next step.
E. Repeat for all Landing Pads.
NOTE: Final tightening will happen in the next step.
Choose the most
appropriate pad
based on the
contour of the roof,
and assemble the
pads to the bases.
D
WARNING: DO
NOT ALLOW
EDGES OF
PAD TO CURL
UNDER!
4X
C
4X
